|
|
v6.0.1 Instructions for Rx60
|
|
|
1. DEFAULT SETUP
- For Train with reversable Motor.
- This receiver has full stick Ch1 throttle control enabled ('low' stick is off and has separate 'direction' channel) (video).
- This gives greater 'stroke' for easier throttle control.
| Output | Type |
| Orange wires |
Motor Ch1 motor 'full stick' control (low off) Ch3 forward/reverse 'direction' change |
| Red/Brown wires | Battery (3-6v) |
| Arming/Activation: | Ch1 low to enable |
| LVC |
Ch1 low to acknowledge (LVC=Low Voltage Cutoff) |
| Variant |
Rx60-1 | Rx60-2 | Rx60-3 | Details |
|
Purpose: |
Train with joystick Tx |
Train with Tx21 |
Conven- tional |
Rx60-1 default is Ch1 for Throttle (non-centering joystick) Rx60-2 default is Ch1 for Throttle (center off) Rx60-3 default is Ch3 for Throttle (self-centering joystick) |
|
H1 output Brown wires |
Motor Ch1 Low off Ch3 Direction |
Motor Ch1 Center off |
Motor Ch3 Center off |
Integrated forward/reverse ESC for brushed motors |
|
P1 |
Led | Not used | Servo | - |
|
P2 |
Front Light Ch4 Right |
Front Light Direction switch (Ch3) |
Servo |
Direction switch used as on/off Led needs current limiting resistor |
|
P3 |
Servo |
Rear Light Bind button (Ch5) |
Servo |
Bind button used as latching on/off switch Push for on and release Push for off and release Led needs current limiting resistor |
2. BINDING (perform once):
1. Switch Rx on and wait ~20s until led flickers fast.
2. Switch Tx on in bind mode and Rx led should flash slowly and then go solid.
3. Change distance between Tx/Rx if binding does not work.
3. LED:
Led On = perfect reception (real-time indicator).
1 flash = Scanning (~2sec between flashes; no signal or not bound if never stops).
2 flash = LVC/Brownout (voltage went too low; check battery/motor load).
4. FAILSAFE:
The motor output is not active on startup and while scanning for a signal.
The motor output 'holds' last known settings on short signal losses (<1sec) and then cuts (>1s).
5. OTHER:
This receiver has other outputs and features that are not described.
See Rx41d-v5 for full capability.