Videos


SELECTA FEATURE

N and HO locos controlled with Tx22. Locos both have Rx60-22 receivers using the Selecta feature to bring them in and out of service. 3 switch positions are used. Neither loco is being actively controlled when the switch is in the '3rd' position. This is used to position the throttle in the correct position for the loco that is selected next.


'V5' CAR, TRAIN, BOAT RECEIVERS

Rx43d-2-v5 in 3" Como 'Guppy' boat. Geared 4x8mm pager motor, home-made brass prop, 50mA lipo, actuator rudder. Motor drive frequency set to its lowest speed in the receiver for realistic 'pop-pop' sound.
Forward/reverse with 'full stick' throttle settings and separate 'direction' channel.
Train intended for 12v has ample speed with 1S lipo and Rx41d-v5.
N gauge Minitrix 0-4-0 engine on 103mm Tomix track
Forward/reverse with 'full stick' throttle settings and separate 'direction' channel.
Rx41d-v5 under chicken wire and carbon fibre with Tx21.
Tx2 'Inertia' feature for trains.
Rx45-v5 demonstrating control over front lights, rear, brake, reverse, indicators, harzards, roof flashing light, forward/reverse motor and steering.
Rx43-3-v5 demonstrating control over 3 motors with integrated forward/reverse left/right steering mix.


BINDING

Binding Rx31d with Parkzone/MLP4DSM transmitter.
Binding Rx31d with TX1-M transmitter.


PROGRAMMING RECEIVERS

v5.x.x
Changing 'P2' output from Ch4 to Ch5:
Level 1: 3-flash = P
Level 2: 2-flash = P2
Level 3: 1-flash = Servo
Level 4: 5-flash = Ch5
v3.4.x
Enable twin-steer:
Level 1: 1-flash NO (down elevator), 2-flash NO (down elevator), 3-flash YES (up elevator) = Option 3 (25%) & move to next level
Level 2-6: YES to all (no changes).
v3.3.x
Programming SumPPM on Rx36.

Home Videos About Buy Email