|
|
Rx105-v110 - Programming
|
1. PROGRAMMING APPROACH:
The type of output for each Rx105 Pin can be changed using Prog3 or Prog4. One output is changed at a time.
Prog3 Pin 1 - always 1-flash.
Prog3 Pin 2 - selects the receiver's output number (eg: 3-flash = Pin3).
Prog3 Pin 3 - selects the type of output (eg: 1-flash = servo).
Prog3 Pin 4 - selects the controlling channel number (eg: 4-flash = Ch4).
Prog3 Pin 5 - selects the switch position for lights. The number of flashes can be anything for other output types.
2. PROGRAMMING OPTIONS:
|
Prog3 Pin 1 |
Prog3 Pin 2 Output number |
Prog3 Pin 3 Output type |
Prog3 Pin 4 Channel number |
Prog3 Pin 5 Options |
Information |
| 1 flash | 1-8 flash = P1-8 |
1 flash = Normal servo |
1-7 flash = Channel 1-7 | ||
|
|
|||||
| 1 flash | 1-8 flash = P1-8 |
2 flash = 'Signal' servo |
1-7 flash = Channel 1-7 | ||
|
|
|||||
| 1 flash | 1-8 flash = P1-8 |
3 flash = On/Off led |
1-7 flash = Channel 1-7 |
1-flash = ON when channel is LOW 2-flash = ON when channel is MID 3-flash = ON when channel is HIGH |
One channel can control 1, 2 or 3 leds |
|
|
3. ADVANCED IMPLICATIONS:
Throws of channels associated with Pins 1-5 can be changed as described in the Rx105 instructions.
To change throws for channels associated with Pins 6-8:
* set them up temporarily on Pin1, 2, 3, 4 or 5
* change them as required
* reconfigure the Pins for the correct function/channel.
The changes to throws will be 'remembered' even when that channel is no longer associated with Pin 1-5.