|
|
v5.0.3 Instructions for Rx41d-v5-W
|
|
|
|
|
1. DEFAULT SETUP
- For Train with reversable Motor.
- This receiver has full stick Ch1 throttle control enabled ('low' stick is off and has separate 'direction' channel) (video).
- This gives greater 'stroke' for easier throttle control.
| Output | Type |
| Orange wires |
Motor Ch1 motor 'full stick' control (low off) Ch3 forward/reverse 'direction' change |
| Red/Brown wires | Battery (3-6v) |
| Arming/Activation: | Ch1 low to enable |
| LVC |
Ch1 low to acknowledge (LVC=Low Voltage Cutoff) |
2. BINDING (perform once):
1. Switch Rx on and wait ~20s until led flickers fast.
2. Switch Tx on in bind mode and Rx led should flash slowly and then go solid.
3. Change distance between Tx/Rx if binding does not work.
3. LED:
Led On = perfect reception (real-time indicator).
1 flash = Scanning (~2sec between flashes; no signal or not bound if never stops).
2 flash = LVC/Brownout (voltage went too low; check battery/motor load).
4. FAILSAFE:
The motor output is not active on startup and while scanning for a signal.
The motor output 'holds' last known settings on short signal losses (<1sec) and then cuts (>1s).
5. OTHER:
This receiver has other outputs and features that are not described.
See Rx41d-v5 for full capability.