|
|
DT Receiver - Rx43d-32 - v520 Instructions
|
|
|
|
|
1. DEFAULT SETUP
- 2-way ESC x3
- 1-way ESC x2
- Servos x4
- All outputs can be customised / re-configured.
| Output | Type | Channel |
| H1: | Motor 1 (center off) | Ch1 |
| H2: | Motor 2 (center off) | Ch2 |
| H3: | Motor 3 (center off) | Ch3 |
| F1: | Motor/Switch | Ch7 |
| F2: | Motor/Switch | Ch6 |
| P1: | Servo | Ch4 |
| P2: | Servo | Ch5 |
| P3: | Servo | Ch6 |
| P4: | Servo | Ch7 |
| Arming/Activation: | Mid-stick to enable | Ch1 |
| LVC |
Mid-stick to acknowledge 5-flash |
Ch1 |
2. EXAMPLE CONNECTIONS:
|
|
for extra H output |
|
|
|
|
|
LEDs with 1S Lipo:
Led's driven from P outputs only require a current limiting resistor (8mA max).
Led's driven from F outputs only require a current limiting resistor (2A max).
LEDs with 5-6v:
'P' outputs are 3v when 'off' and 0v when 'on'. So when used with higher voltages, the leds driven from P outputs also need diodes to reduce the voltage. This is because 5 or 6v is high enough above the 3v output to make Leds conduct even when P outputs are 'off'. An example is shown in the Led (P1) diagram.
Led's driven from F outputs only require a current limiting resistor when operated off any voltage up to 6v.
GRAIN of WHEAT:
Grain of Wheat bulbs usually draw >8mA so are not suitable for use with P outputs (unless buffered with a transistor).
Grain of Wheat bulbs can be driven from F outputs. F outputs allow the intensity to be varied with stick movement or 'Travel Adjust'.
3. CHANGING OUTPUTS:
All outputs can be customised / re-configured:
PROGRAMMING
4. GENERAL:
The Rx is not insulated.
The PCB is thin so do not bend it.
5. LED:
Led On = perfect reception (real-time indicator).
1 flash = Scanning (~2sec between flashes; wrong model if never stops).
2 flash = Selecta (model not active).
5 flash = Brownout (receiver voltage went too low; check battery/servo load).
6. FAILSAFE:
Outputs are not driven (do nothing) on startup and while scanning.
Outputs 'hold' on short signal losses (<3sec) and then do nothing (>3s).
7. BINDING:
1. Switch Rx on and wait ~20s until led flickers fast.
2. Switch Tx on in bind mode and Rx led should flash slowly and then go solid.
3. Change distance between Tx/Rx if binding does not work.